Mopar Small Block W2, W5 and LA Engine Parts. All prices exclude shipping
New Mopar wide valve covers Part # P4532754 (previous # P4876124) that support W2, W5 and other LA type cylinder heads. These may also work for other W series Mopar Performance heads like W7, W8 or W9 but I am not certain. These are wider than other LA valve covers by including the gasket rail under the edge of the valve cover to allow additional interior clearance for aftermarket rocker arm systems, valve springs and pushrod configurations. Some modifications to the underside rails may be needed depending on your setup. Price is $830 plus shipping
W2 Small Block Mopar Head Castings, intake and rocker arm assembly
One new set of new pair of W2 race head casting number ending in 810 as delivered by Mopar. This head requires the use of offset drilled blocks and shafts or T&D or Jesel rocker systems. It has 3/8 valve guides, 18 degree valve angle and open chamber combustion chambers. Total price for these bare castings is $1,200 plus shipping
I have a set of Mopar W2 aluminum 1.5 ratio roller rockers, offset drilled blocks and shafts that will work with the above head castings. The rockers have been clearance for additional valve retainer clearance. $950 plus shipping
I have 16 new Mopar Performance 1.5 ratio roller W2 exhaust rocker arms for the W2 & W5 Race heads using offset drilled blocks and shafts. I will sell individual rockers or sets of 2, 4,6 or 8 as needed. Individual rockers are $40 each shipped. A set of 8 is $280 shipped.
New small block Mopar LA single plane M1 intake manifold with fuel injection bungs welded in. $375 plus shipping
New Comp Cams solid roller camshaft for small block Mopar engines. Part number is 20-999-3. This cam is made from billet material. Specs of the cam are intake & exhaust
Lift with 1.5 ratio.645” / 0.633”, duration @ 0.050 272 / 280 degrees and LSA 106 degrees
$450 plus shipping
New 8 BRC forged flat top pistons, pins and locks for 3.79” crankshaft (1.57” compression height) using stock 0.984” wrist pin. 4.030” bore. $475 plus shipping
New sets of small block LA head shaft hold down kit including the 10 blocks as well as ten 12 point 5/16” bolts and washers. Price is $90 plus shipping
New set of 16 PAC dual valve springs with damper, part # PAC-1243, Trick Flow 10 degree titanium retainers and Comp Cams 10 degree Maximum Lift (in.):0.700 in., Diameter 1.550 in., Coil Bind 1.100 in., Spring Rate 550 lbs./in. $550 plus shipping
I have several new small block Mopar solid flat tappet cams
New U.S. made Mopar forged 3.79” stroke crankshaft with 8 bolt flange from the 1990’s. Part # P4529715. Stock 340 main and rod journal dimensions. $950 plus shipping
I also have a new 360 stroker kit that comes to 408 ci and a new 340 main stroker kit that comes to 414 ci. Both kits contain new SCAT 4.0” crankshafts, new SCAT H-beam rods, new Sealed Power and Clevite bearings, new moly rings, new Diamond flat top pistons and locks, and new Trend wrist pins. Assemblies will need balancing. Price for each kit is $2,750 plus shipping.
I have quite a few other parts. Let me know what you are looking for.
I will arrange all shipping and accept PayPal or COD.
I will ship internationally for the added cost. Contact me with any questions.
