Originally Posted by mrmopar622
[img]
This is page 1 of dyno sheets[/img]
As you can see, this is the way a real dyno sheet should read out. It should show the average 3 best pulls. I will put the graph from the pulls in the next section. Any dyno operator can look & compare the graphs to determine if the numbers are exact. As you notice, Naylor did not include that on his.
But he did prove what I have been telling him & everyone on here - a 632 cu in should make 1000-1050 hp easy with 1 four barrel. My engine has a Tunnelram & made a best of 947 hp at 6400 rpm, anything over 6400 rpm the horsepower starts dropping off.
That means there is a problem somewhere, something is NOT right, that is what I have been trying to get Naylor to address.