BBC Block Questions?
Howdy Ya'll
I am new here.
I was told this is the place to come to build an engine on a budget.
Unfortunately I not there yet but am listening to others advice.
I hope to eventually build an E-85 engine for a Pro-Street Camaro, Street/Show usage Spring/Summer/Fall(60-75%), Race(25-40%).
I was told a good "Street/Strip" combo is a 482(std bore 454 with a 4.25 stroker crank) or a 505 (+.100 overbore and a 4.25 stroker crank).
I would like to have a 12:1 CR with Aluminum heads, a Holley Pro-Ram Tunnel Ram with twin E-85 830 carbs, a solid roller cam (LSA 112-114) for use with a small N2O Fogger System, forged crank,rods and pistons.
Assuming a 3100-3300 lb car, 31-18.5-15 M/T ET Street tires, a TH200-R4 tranny(2.74 1st gear), 4.88-5.13 rear gear, and a desired Flywheel
output of 600-700 HP what HEADS & Cam would you suggest?