going with an isky hydraulic roller
cam card here.
anyone use this cam ?
i got 3:93 rear ratio and 2500 stall converter on a built th350.
brodix -10 aluminum heads
11:1 compression
also I got 150 nitrous shot on the plate.
will this cam work ????
thoughts???
TIMING CHART
PART NUMBER: 211282/294GRIND NUMBER:
rr-282/294ENGINE INFO:
CHEVY SMALL BLOCK V8 305-350 CU.IN. 1988-UPAPPLICATION: SPECIAL REMARKS:
HYDRAULIC ROLLERPRODUCT USE:
STREET/STRIP
RPM RANGE: 3000-7000Valve lift is calculated with zero lash and rocker ratio of 1.5INTAKE TIMING DURATION:
282deg.OPEN:
31BEFORE TDCCLOSE:
71AFTER BDCCAM LIFT:
.353"VALVE LIFT:
.530"VALVE LASH:
.HOT
.COLD
EXHAUST TIMING DURATION:
294deg.OPEN:
77BEFORE BDCCLOSE:
37AFTER TDCCAM LIFT:
.367"VALVE LIFT:
.550"VALVE LASH:
.HOT
.COLD
LOBE CENTER:
110 deg.OVERLAP:
68 deg.CAM ADVANCE:
0 deg.THE ABOVE TIMING IS CHECKED AT
.020(OPEN) LIFTER RISE.020(CLOSE)
The following timing is taken at .050" lifter rise and gives a more accurate determination of camshaft position.
INTAKE DURATION:
234deg.OPEN:
7BEFORE TDCCLOSE:
47AFTER BDCEXHAUST DURATION:
246deg.OPEN:
53BEFORE BDCCLOSE:
13AFTER TDCRECOMMENDED ISKY CAM KIT PARTS AND SETUP INFORMATION
LIFTERS:
USE STOCKLIFTER TYPE:
HYDRAULIC ROLLERSPRING:
6105TYPE:
dual W/DAMPERDIA.:
1.430"RATE:
330 lbs per inchINSTALLED HEIGHT:
1.812"SEAT PRESSURE:
135 lbsOPEN PRESSURE:
315 lbsCOIL BIND:
1.120"SPRING SHIMS:
# 2STEEL RETAINERS:
507-STATITANIUM RETAINERS:
60-TIPUSHRODS:
203-HG-.460"TYPE:
heat treated non-adjLENGTH:
7.200"DIA.:
5/16"ROCKER ARMS:
204TYPE:
rollerRATIO:
1.5VALVE LOCKS:
VL-32VALVE LOCKS:
VL-32REV KIT:
home | what's new | tech info | news | catalog | apparel | about | contact
© 2002 Isky Racing Cams. All rights reserved.