Originally Posted by doorracer
Warren, I think you must have done some good port matching. You don't run the ETs you are if the porting was junk. :shock: :shock:
Curtis
Curtis,
After my port-matching job and after the intake was installed, I looked down the runners on the Wheeler and every intake port appeared to match-up perfectly with my Dart Pro-1 head ports. The FelPro 1206 gasket was also perfectly aligned on each port and didn't protrude into any of the runners.
I think there was both some luck and skill involved with the results. But, I've always had those second-thoughts about the Wheeler and that I could have used a better intake (Victor or Dart).
Warren