Originally Posted by JEFF69Z28
Originally Posted by justin45
well its not gona be raced much and i want to have bout 10:1 compression so i can run pump but i was thinking bout getting 5.7 rods wth flat tops and 2.05 valves wth a big roller, im planning on using the stock heads and crank but im thinking but offgrinding it to stroke it and im not to sure what im gonna forsure do to it yet but i ana build it on a low budget
i have a used cam for sbc 265-400 cid,i took out of my 406 early this year because i had a new solid roller cam,new heads,intake&carb installed.im trying to sell all of it if your interested.engine builder said the cam and valve train looked good.cam is a hydrulic comp cam #12-250/grind#cs xe284h-10.
240/246@50 507/510 lift,carb is aed 750cfm,dont know manufacture of roller rocker arms but they are purple and 1.5 ratio.push rods are comp cam.lifters are comp cam.also have a open plenium intake.this combo with a set of proline heads took my pump gas 3500lb monte carlo to a best time of 11.60 in the 1/4 mile on m/t drag radials.you can have it all for $400.00.if you need pic's let me know and i can e-mail some to you.and yes i did drive the car on the street.
You guys need to pm each other. This is not the classified section.