I am with Ed. Dart usualy, I say usualy, as there are exceptions, do a pretty good job on the mains. We usualy install studs, and touch up the line hone, and, we always cut the decks, with the BHJ fixture, but, the are very close, its just the finish isn;t always that great. I like Cometic and MLS fel-pro's, and just like to put the correct finish on it.
I did see a Dart block on Thrusday, that appeared to have only been line bored, or, an EXTREMELY smooth diamond line hone finish on the mains. It was very smooth, and very shiny, but, you could see some very fine angled lines, like from a honing process. Anyonw know if this is a recent change?
Frank
Advanced Performance
www.get-ap.com