i will have to agree with Frank...the word 'MILDY PORTED" is very important here...make sure you trust your head guy..if he does too much work on those heads..its not gonna be good for the street....you would be better off with a cast set of good oval port aluminum heads before overkill port job...if it were my steet motor i would have the bowl work done and maybe port match the intake...if any port work other than this would be just rough up some sweet spots...if your head guy is good ..he will know where this blend should be.....and thats it...
Brian
__________________
Bjuice..
"I'M YOUR HUCKLEBERRY ! "